World Class Driveshafts
SALES
and TECH HELP
800-845-6326 602-253-8006
Customer Service for order status and repairs 888-222-8610
602-253-8208
FAX
602-252-5638
ADDRESS
2417 WEST Lincoln St Phoenix AZ 85009
World Class Driveshafts
SALES
and TECH HELP
800-845-6326 602-253-8006
Customer Service for order status and repairs 888-222-8610
602-253-8208
FAX
602-252-5638
ADDRESS
2417 WEST Lincoln St Phoenix AZ 85009
A new meaning to heavy duty SUZUKI DRIVE SHAFTS
Experience drive shafts that will take you any where !!! These are the front and rear for a Sumo !!!
Made of half ton u-joints and 250 wall tubing with heavy duty long splines that are so strong we warranty them for life time from breaking and twisting. And if that is not enough, you get flanges that allow thirty degrees and CV that flex to 40 degrees and that fit your flanges. We back our workmanship such that all welds are warranted for as long as you have the drive shaft.Bullet Proof 1310 U-joints / 30 degree flanges
And they are bolt-on, no modificationsThis is a rear drive shaft without CVs
We and our customers are the inventors and the major supplier of Heavy Duty
High Angle Long Spline Suzuki, Jeep, Blazer and Tahoe Super Duty drive shafts
Information Needed on Order Form
The vehicle and transfer case you have.
The working length of the drive shaft to be built between the transfer case and the differential.
Do you have a yoke or a flange?
See How to Measure A Drive Shaft if needed so you know how to record your measurement. Enter your front working length or your rear drive shaft working length as it applies.
Front Drive ShaftsNote: The large or small hole patterns we will know by the year of the vehicle or by your comments during check out.
LOOK!!!All guaranteed not to twist or we make you a new one.
Front drive shaft with high angle CV and standard splines 
Front drive shaft with high angle CV and long splines 9" 
-- $350.00 1 1/4" 250 wall tubing Like the ones above except with a CV at the transfer case.
Front drive shaft with no CV and long splines 9" -- $265.00 1 1/4" 250 wall tubing.. Like the four shown above
Front drive shaft with no CV, no long splines, just large 1310 u-joints and/OR
Rear Drive Shaft LOOK!!!No twisting or you get a new one.
Rear drive shaft with high angle CV and long spines 9"-- $350.00 
Rear drive shaft with no CV and long spines 9"-- $265.00
Rear drive shaft with no CV, no long spines, just large u-joints and flanges -- $225.00 
Rear drive shaft with STD Spline High angle CV no long splines-- $265.00