World Class Driveshafts
SALES
and TECH HELP
800-845-6326 602-253-8006
Customer Service for order status and repairs 888-222-8610
602-253-8208
FAX
602-252-5638
ADDRESS
2417 WEST Lincoln St Phoenix AZ 85009
World Class Driveshafts
SALES
and TECH HELP
800-845-6326 602-253-8006
Customer Service for order status and repairs 888-222-8610
602-253-8208
FAX
602-252-5638
ADDRESS
2417 WEST Lincoln St Phoenix AZ 85009
| Dodge |
CLICK HERE FOR CUSTOM DODGE DRIVE SHAFTS
ALL NEW PARTS
DODGE Front Saginaw CV Drive shaft with a small Chrysler u-joint at the axle.
For angles higher than the stock, look at Dodge custome drive shaft and then to the generic custom drive shafts. Higher and higher angle CVs.
$210 no core
'76 AND BELOW DODGE with small chrysler u-joints rear drive shaft with no CV one u-joint on each end with a slip in the middle.
$185 Built to last with thicker tube.
____________________________________________________________________________
'99 AND UP Stock Dodge Diesel rear Drive Shaft with no CV one u-joint on each end with slip yoke. Specify the number of splines and the outer diameter on the yoke round part.
$295
You get the complete and precision balanced stock drive shaft. Please note that is the vehicle is lifted you will need a CV style slip yoke with CV drive shaft. See below.
____________________________________________________________________________
'99 and up DODGE Standard Angle ONE TON CV Slip with CV Drive Shaft. This eliminates vibration due to a lift up to 10 inches.
Eliminates vibrations by effectively lowering the angles.
You get the complete and precision balanced drive shaft
-- $325.00
Saginaw type Stock 1350 CV drive shaft complete and preision balance-
- $325.00
FOR LIFTED VEHICLES CLICK HERE
______________________________________________________________________________________________________
Dodge Rear Diesel STOCK Two-Piece
precision balanced
call us for how to measure
FOR LIFTED VEHICLES CLICK HERE
Dodge Diesel Two-Piece -- $375.00
______________________________________________________________________________
Dodge Dakota FRONT Drive Shaft
being worked
We have ready-made tubes. Measure Center to Center of u-joint on you tube or from the seal of the transmission to the center of the u-joint at the pinion and let us know.
We will make you one that size with aluminum or convert it to steel for the same price with u-joints and precision balanced.
We do need to know, if you have a flange on the rear and the type of yoke you have.Information you need to specify on your online order form:
Center u-joint to center u-joint measurement
Complete Shaft no core required --$275
