DRIVESHAFTSUPERSTORE

World Class Driveshafts

SALES and TECH HELP
800-845-6326 602-253-8006 

Customer Service for order status and repairs 888-222-8610

602-253-8208

FAX

602-252-5638

ADDRESS       

2417 WEST Lincoln St Phoenix AZ 85009

 

 

 

 

 

Catalogue

Customer Service

Contact Us

About Us

4x4 Links

4x4 Gallery

4x4 Videos

4x4 Babes

 

World Class Driveshafts

SALES and TECH HELP
800-845-6326 602-253-8006 

Customer Service for order status and repairs 888-222-8610

602-253-8208

FAX

602-252-5638

ADDRESS       

2417 WEST Lincoln St Phoenix AZ 85009

 

How to measure a U-joint


Outside Clip U-joint

  1. Measure end cap to end cap across the u-joint. Write down the measurement.
  2. Measure the diameter of the bearing cap. Write down the measurement.
  3. Call us


Inside Clip U-joint (foreign vehicles, Chevy 3r uj)

  1. Measure from inside clip groove to inside clip groove. Write it down.
  2. Measure the diameter of the bearing cap. Write it down.

If You Don't have a U-joint To Measure

Go under the vehicle to the yoke in question. That is, at the transmission or transfer case  or at the pinion of the differential.

 If the yoke has two tabs where the u-joint fits right in the middle, measure from inside of tab to inside of tab. Write it down.

>>Measure the opening of the yoke where the bearing goes in. Carefully measure from edge to edge to the sixteenth mark. Write it down.

If the yoke does not have two tabs. The yoke does not have two tabs keeping the u-j from sliding sideways. The bearing beds are slick and no tabs. This is an inside clip yoke. Measure from inside of yoke ear to the other inside of the second ear. Write it down.

 >>Carefully measure edge to edge where the bearing goes in the yoke to the 1 /16 resolution.


For comparison of measurements, go the the COMMON U-JOINT SECTION and see if you can match your measurements.

 

ANY UJOINT OF OURS BREAKS IN TWO WE REPLACE IT FREE OF CHARGE