We make Eliminator Yokes and for any other transfer
cases. If you have a transmission slip yoke we can eliminate it!!!
Slip Yoke
Eliminator for FORD
Borg Warner 1356 transfer case slip yoke eliminator. Bolt after drilling
and tapping a hole at the of the output shaft. The flange front 31 spline
flange.
Supports:
1350 CV 2 inch
pilot SYE for Ford -- $185.00
|
1350 CV 2.688 inch
pilot SYE for Ford -- $185.00
|
Slip Yoke
Eliminator (SYE) Yoke
for the np241, np205, and np208 slip yoke type transfer cases
This is a fully splined 1
7/8 inch seal surface diameter slip yoke only. You can bolt this one on
after drilling and tapping a hole at the end of the output shaft.
Any slip yoke transfer case can have an SYE made for it. This
includes Dodges, Fords, Chevys,.. As long as it is a slip yoke, it can be
eliminated.
Size of CV needed on the SYE Yoke
FOR 208 SYE COMPLETE KIT
CLICK HERE
This flange is 32 spline and is installed just
like the yoke except that the purpose of a flange is to support the use of
a one-ton (1350) CV or a Saginaw (GM) CV like from a front of a 77 and up
Chevy pick-up or Blazer.
Large flange style
2.0 pilot SYE -- $185.00
|
Large flange style
2.688 pilot SYE -- $185.00
|
Wrangler 27
spline slip yoke eliminator CV style or U-joint style
Yoke only
These slip yoke eliminator Yokes
are made custom and fit jeep 207, 242, 231 transfer cases and turbo 350
transmissions (for low rider fixed yokes when using our long slip shafts).
This flange is 27 spline
and is installed just like the yoke except that the purpose of a flange is
to support the use of a one ton (1350) CV or a Saginaw (GM) CV like from a
front of a 77 and up Chevy pick-up or Blazer.
1310 u-joint style
Wrangler 27 spline yoke eliminator -- $165.00
|
1310 CV style
Wrangler 27 spline SYE -- $100.00
|
1350 flange style
Wrangler 27 spline SYE -- $185.00
|
|